The best way to give a new look to your interiors is by plastering them. It can be done by yourself or done with professional help. Expert tips are needed so that you can plaster the wall yourself. In case it is a replacement, you need to first consult an expert in the drywall installation industry or a company that provides the service before you remove and reinstall. Read on for a brief guide to wall lining.
Before You Begin
Make sure the lath and plaster are lined over the timber. To get a better framing, and finish, this step should be followed. You require some help from GIB stoppers Auckland if you are new to the plastering area. It is something that needs to be done very carefully and before replacement, you should ensure you are consulting someone before removing the wall. Sometimes the bracing over of plasterboard can come under restricted building work and you need a certified professional’s supervision to carry out such tasks.
Storage of Plasterboard.
To prevent any damage to edges, ends, and surfaces, the plasterboard sheets are required to be stacked in a clear flat stack with proper care. There should only be 20 stacks of 20 sheets and if you store it on a non-concrete surface, there is always the risk of damage on the surface related to point loading. It should also be packed up on a polythene sheet so that it does not catch moisture and should be also placed in an elevated position.
Handling and Prep Work
Since plasterboard is an essential finishing material, it should be handled with extra care. Sitting or walking on the sheets can damage it. The sheets are easy to carry and they should be carried by its edge. They cannot easily break or crack. Make sure not to drag any sheets while taking a sheet from the stack as it can lead to deterioration of the face paper. The following are the steps to prep the wall.
- Detach nails, old glue, and other fixings from the timber.
- Plane or straighten misaligned areas or high areas.
- The moisture content of the timber should be less than 18%. A joint distortion can be caused beyond this point.
- There should not be any deviations in framing. The flatness and smoothness of the wall should be checked before you proceed.
- Vertical joint fixing should be made over timber. Even though the suggested method of joining timber is horizontal, it is not possible most of the time.
Imperfections must be hard to see when you fix all the joints horizontally. Gluing and screwing decrease the use of mechanical fixings on the plasterboard. For existing homes, trimmed plasterboards are required for vertical stud spacing.
